Visit The Dirt Forum for More Information


Note: This is an archived topic. It is read-only.
  The DIRT Forum
  PureStock/Bomber Tech
  car unloads in center, loose off

profile | register | preferences | faq | search



This topic was originally posted in this forum: Modified Tech Talk
Author Topic:   car unloads in center, loose off
flip728
Member
posted April 22, 2004 11:48 PM     Click Here to See the Profile for flip728   Click Here to Email flip728     
Going into corner good,in center car drifts high and develops massive push, off corner car loose when i get back to throttle. Please help totally confused.


Ego Racing
Member
posted April 23, 2004 12:16 PM     Click Here to See the Profile for Ego Racing   Click Here to Email Ego Racing     
What rear %? How about rear steer? What Rear Springs?


Wauge28
Member
posted April 23, 2004 01:22 PM     Click Here to See the Profile for Wauge28   Click Here to Email Wauge28     
More info. Does it push when you get on the gas? -or- Does it start drifting before you get on the gas?

If on the gas, too much LR bite/cross. Too much traction. Less pull bar angle, too far to the left on rear housing. no rear steer...etc.

If it drifts before you get on the gas, too soft RF spring.

The loose off is more than likely just because the car is too tight or just bad in the middle. Get rid of the middle problem and the off will probably get better as well.

harlow129
Member
posted April 27, 2004 08:28 PM     Click Here to See the Profile for harlow129   Click Here to Email harlow129     
good chance car is not loose off but because you are trying to correct car for push by the time you are coming out of turn you are crossed up making you think its loose i fought that for a while check your cross that sounds like your problem


Back to the Archives