Visit The Dirt Forum for More Information

Author Topic:   Best Cam per Rules????
outlaw#03
Member
posted November 18, 2004 03:24 PM
if the lift is messured at the bore then you take that times the rocker arm so a 444 and1.6 rocker could be a 710 i'd double check that rule


juliaferrell
Member
posted November 18, 2004 08:18 PM
I would take that route of the 444 lift off the lifter bore. Then hush my mouth about the rest. Put my monster in there and beg them to check it.



Pigpen
Member
posted November 19, 2004 07:19 AM
The rule was .294 at the lifter but this year it changed to .300 or 15" of vac at 1000 rpm... but I thought you were "outlawed" mike... AJ


outlaw#03
Member
posted November 19, 2004 04:35 PM
Are they going to the .300 for next year...we might run there some... by the way I like the lift rule since you know it will pass tech, I hate to worry a vac. leak might cause me to be dq...also the cam companys I talked to could not guarantee that a cam would pull 15" if you tried to get close, they would say it should, but I hate gambling and I dont want to try two or three...... AJ (aka King of the Outlaws)

[This message has been edited by Pigpen (edited November 19, 2004).]