Visit The Dirt Forum for More Information

Author Topic:   heads
jeff woodson
Member
posted July 04, 2004 09:12 PM
i recently bought a set of racing angle cut vortec heads, 2.02in i noticed the intake valves are about .025 or more below the bottom of the head i am going to run flat tops with the eyebrows on one side does any one see a clearance problem here @tdc? please give me some advice thanks. springs are .600+ lift

[This message has been edited by jeff woodson (edited July 04, 2004).]

bigcityracer
Member
posted July 05, 2004 07:14 AM
Should be fine. Check basic valve clearances while assembling.


Back to the Archives