Visit The Dirt Forum for More Information

Author Topic:   Pistons
OLSONRACECARS
Member
posted June 28, 2004 10:38 PM
Building new motor 60 over 350 with 3.562 stroke and 6 inch rod does anyone know who makes resonably priced pistons for this combo. ends up being a 369


KPLugnut
Member
posted June 29, 2004 11:47 AM
CP, Ross, and Mahle come to mind. Be prepared to spend nearly $100 per piston, tho.

KP

chomme
Member
posted June 29, 2004 12:30 PM
Not a very common piston, probably looking at custom set at the $100/ea. mentioned above.


hamer36
Member
posted June 29, 2004 03:13 PM
check ebay...


OLSONRACECARS
Member
posted June 30, 2004 10:20 PM
Thanks for the input didn't want to spend that much. So I'am just going to run stock stroke and 6" rods


15a
Member
posted July 01, 2004 12:51 AM
Comp height on the 3.5625 stroke is 1.227 i believe. Ross makes them off the shelf, probaly $400.00 plus a set.



Ells949
Member
posted July 01, 2004 06:29 PM
15A Looked at that but need a domed piston to get the compression I am looking for about 13.5. Checked on the ross and they were about 700 bucks too rich for my blood. Ells949 the block was 40 over and burned a piston and scored a wall so I had to go 60 or put a sleve in so I went to 60 but thanks for the help.


Back to the Archives