Visit The Dirt Forum for More Information

Author Topic:   DART Iron Eagle ???
monteregal7
Member
posted June 09, 2004 11:06 AM
What is the safe plaining amount? I've heard .180. Have 64cc heads and want to plane to 50cc. If I figured right the should be .100. I heard .007 = 1cc.


dirtbuster
Member
posted June 09, 2004 11:54 AM
.060 is the max flat mill and that gets you to about 58cc. You can angle mill more than that but would also have to redo all your bolt holes and intake face.


stockcar5
Member
posted June 09, 2004 03:57 PM
you can go to around .200 angle mill. i think that gets you arond the 50cc mark.

luke

------------------
www.geocities.com/dirtstockcar5


BrianW
Member
posted June 09, 2004 04:07 PM
Why not sell the heads and buy their 50cc heads? Might cost about the same or even less by the time you angle mill the heads, mill the head "face" and then mill the intake so the ports will line up....


fast_crew
Member
posted June 11, 2004 06:08 PM
Hendrens cuts there's to about 35cc cut .380ths
Josh K.


2nd2none
Member
posted June 17, 2004 01:51 PM
quote:
Originally posted by fast_crew:
Hendrens cuts there's to about 35cc cut .380ths
Josh K.

Bill does an awesome job taking them down this far.

[This message has been edited by 2nd2none (edited June 17, 2004).]

Back to the Archives