Visit The Dirt Forum for More Information

Author Topic:   Wet Sump
Matt22
Member
posted April 21, 2004 01:09 PM
You just need an adapter for the block that has in and out oil lines on it. Run the pressure out line to the cooler then from the cooler to the relocated filter and then from the filter back to the other block adapter fitting into the engine. Oil would be pumped out of then engine through the cooler through the filter then bacl to the engine and from there on it would be the same as a stock oiling system.


chomme
Member
posted April 21, 2004 01:17 PM
also forgot to mention that we run melling oilpump, oil cooler, and block adapter that lowers the filter but keeps it in stock location and everything works fine. Just try to avoid sharp bends and 90 degree fittings in your lines.


Matt22
Member
posted April 22, 2004 11:44 AM
Thanks Guys. Should I have no 90's in it or try to just keep them to a minimum?


chomme
Member
posted April 22, 2004 10:55 PM
I would try to run no 90's...but if you have to run them, just buy the ones with the least restriction you can find and it should work fine. Same as the fuel system, minimum bends in it. Good luck!


Back to the Archives