Visit The Dirt Forum for More Information

Author Topic:   Rocker arm alignment
Fomocosho
Member
posted March 14, 2004 11:30 AM
I bought a set of used 487x heads at a swap meet they had screw in studs and guide plates. The problem is that the rocker arms are shifted off to the side of the valve stem. There are only a couple on each head like this. What caused this? Poor machine work? Is there any way to fix it?

Thanks

Sidebite252
Member
posted March 14, 2004 05:40 PM
Sounds like the guide plates may be off.


joetaylor
Member
posted March 14, 2004 06:25 PM
loosen the studs and adjust the guide plate you may have to long gate the holes to get enough room to adjust

------------------
U LIFT U LOOSE


Back to the Archives