Visit The Dirt Forum for More Information

Author Topic:   intake water leak
motorsport 18
Member
posted March 09, 2004 05:09 PM
i have a brodix track 1 heads with a victor jr intake and have a water leak in the left front corner of the intake do they make a different gasket for the alum head may be thicker one everything is true and flat and all new i have a resin felpro med port gasket on it right now


Raz_900
Member
posted March 10, 2004 08:26 AM
When I was machining my new motor I also milled my intake flanges (had angle milled the heads and needed to correct the angle anyway). It's an Edelbrock Performer. The outer edges (by the outside 4 bolts) was warped about .010"-.015" on all 4 corners. After milling it about .007"-.010" the corners were still untouched about 1/2" down on all the corners. This was a used intake, but I'm wondering if it was like that from the factory. It wasn't used all that long. Never know...




Back to the Archives