Visit The Dirt Forum for More Information

Author Topic:   Setting solid mounts
RACEINMUD
Member
posted March 08, 2004 10:38 AM
Hi, going to set up my metric with solid mounts. What do I need to watch for? Got bare block, bolted to my glide. Thought I would set in and bolt up tranny then mark where mounts set and weld up. Is there more I need to do? Thanks! Race


sixwillwin
Member
posted March 08, 2004 01:14 PM
allow for the largest oil pan that you may run, also, check for the fuel pump clearance on the crossmember. check header/exhaust clearances also....


sixwillwin
Member
posted March 08, 2004 01:15 PM
forgot.....check for level or close to level, check it on the intake manifold where the carb sits....


Back to the Archives