Visit The Dirt Forum for More Information

Author Topic:   i need help
mrbiggsracing
Member
posted February 03, 2004 07:21 AM
iam some what new to the driverseat but iam building a factor stock i have a motor ready but not sure what it will turn i have ran this motor before in an enduro it did very well it's a 350 w/60 over pistions stock crank turned 1010 with a isky cam (not sure what the specs are)and 882 stock heads iam getting a set of z-28 valve spring but not sure what a good cam would be to put in it any ideas would be a lot of help?


Eljojo
Member
posted February 03, 2004 02:49 PM
Why not give Camcraft, one of the sponsors of this forum, a call? They will tell you what information you will need to provide to them and help you to make a cam selection based upon that. They are professionals, and with the camshaft being the single most power-making component in the motor, you'll want the absolute best advice you can get.
Good luck! Jon


mrbiggsracing
Member
posted February 04, 2004 07:35 AM
thanks


Back to the Archives