posted January 27, 2004 03:48 PM
Depending on the experience of the shop, about $150-$250 labor to fit the caps and around $200 for a line bore.
Figure on $650-$750 in the block for clean, mag, cap fitment, line bore, cylinder bore w/deck plate and decking the block. Plus the cost of the caps.
posted January 28, 2004 12:05 PM
ouch! my 351w ford just keeps looking better...
posted January 28, 2004 01:58 PM
You can get the caps anywehre from 100-200$. If you knew what you were doing you could prob drill and tap them yourself if you had the right equipment then have a line bore done. But all in all its prob better to have a shop do it. I think at my shop they charge $350 to install them and i beleive that includes a line bore but you have to buy the caps on top of that.
posted January 28, 2004 05:08 PM
our shop charges around 350. thats with callies caps that are about 160 a set.