Visit The Dirt Forum for More Information
Topic: Cam Bearings
posted October 07, 2003 04:04 PM
Is it hard to change your own cam bearings, or should I just take it to the shop and pay them to do it? If I can do it, any good ideas on how to go about doing it?
posted October 07, 2003 04:36 PM
you need a tool to replace cambearings-take it a shop. be less headach
posted October 07, 2003 04:39 PM
If you don't have the correct cam bearing driver,then your best bet is to take it to the machine shop.If not done right you can ruin a good motor.
posted October 07, 2003 06:52 PM
That's what I'm going to do. Someone told me of a good shop that is real reasonable. $20.00 to pop out the old and put in the new while you wait.
Back to the Archives