Visit The Dirt Forum for More Information

Author Topic:   sbc heads
dirtbandit
Member
posted August 26, 2003 01:19 PM
Best set of double humpers there are. Rare as chicken teeth. In untouched form restorers pay top dollar for 'em. That said, spend your money on aftermarket heads if rules allow.


66jj
Member
posted August 26, 2003 04:17 PM
where do you find all these restorers??

I have some 461x, 461, 041,291,and 462 untouched pairs.

and 4 more sets that are touched some here and there, 040,461,461,291.

Do tell I can use aftermarket now!!!

kcoutlaw
Member
posted August 26, 2003 05:11 PM
66jj,
If you put 'em out there, they'll find you! Ebay, Hemmings, etc...


66jj
Member
posted August 26, 2003 09:18 PM
Ill post it tommorrow, do you want spring specs valves etc, or casting #s??

I have 4 or 5 done sets all a little different so Ill have to look up the cards I keep on the heads.

Thanks jeff

cobb
Member
posted August 26, 2003 10:17 PM
we've got a set of 461's we have to run oem heads-i love those heads but i was thinking maybe going with vortec or world s/r heads we can run those too


66jj
Member
posted August 28, 2003 07:03 PM
I have a set of 291s stainless one piece valves screw in studs plates etc.

springs are 115-350 stock diameter.

valves are 2.02 1.6

no porting etc, not angle milled, ran 3 races since all brand new. the valves are not deep in the head, they have only ever had one valve job at this size vavle.

I really dont car to sell any of my done sets of heads unless I can get enought to buy aftermarket. I can use them just fine, but am not limited to them anymore, so if someone is Ill consider selling a set or two.

Jeff

SS90
Member
posted August 28, 2003 10:03 PM
Looking for one 461X head. 66jj would you have one to sell? Thanks.


66jj
Member
posted August 29, 2003 03:44 PM
sold the pair of 461x heads.

no single 461x

sbc350
Member
posted August 29, 2003 10:59 PM
I have one 461x head. Let me know if you're interested.


FastEddy
Member
posted August 30, 2003 01:08 AM
Help me out here folks. When I went to www.mrgoodwrench.com and looked up the 461 head and the 492 head, they stated that there were the same head only a casting number change in '70. Is that right or am I really confused here?


66jj
Member
posted August 30, 2003 08:37 AM
THATS RIGHT YOU CAN BUY THE 492 BRAND NEW STILL.

JEFF

SS90
Member
posted September 02, 2003 08:15 PM
sbc350 I'm interested in that head.


Back to the Archives