Visit The Dirt Forum for More Information

Author Topic:   Fly-cutting Vortec's?
LeafsRus
Member
posted July 26, 2003 04:32 AM
Flat milling them .045" gives you about 55cc's depending on how thick the valves are that your using .

Steve

------------------
Hendren Racing Engines
Rutherfordton , NC
(828)286-0780


LeafsRus
Member
posted July 26, 2003 03:39 PM
leafsrus do you sell leafs or something??

thanks jeff

ryan
Member
posted July 26, 2003 04:39 PM
Maybe he rakes leafs for a living


sdhnc29
Member
posted July 26, 2003 10:08 PM
I'll have to look at my notes on Monday and let you know . I don't remeber off the top of my head .

Steve

------------------
Hendren Racing Engines
Rutherfordton , NC
(828)286-0780


sdhnc29
Member
posted July 28, 2003 02:30 PM
Going by my notes , the farthest that we have cut them reliably is ..... angle milled .085" with an extra .015" taken off , for a total of .100" . Much more than this and I have seen problems with the deck being too thin to hold a head gasket .

Steve

------------------
Hendren Racing Engines
Rutherfordton , NC
(828)286-0780


Back to the Archives