Visit The Dirt Forum for More Information

Author Topic:   Clearances on 355 Claimer
Wallydog9g
Member
posted April 03, 2003 12:28 PM
Getting ready to build my 355 B-Mod Claimer motor. Speed Pro Hyperutectic pistons, Reconditioned X rods with arp bolts, clevite 77 bearings, roller tip rockers. Had crank ground and polished. What Rod clearances, thrust, main bearing clearances and side clearances between rods should i look for. This is my first 350 i have ever built so i need to know what to look out for while building the engine. I am good with engines because i have built kart engines for a few years with many wins. All i need to buy now are some bare 441 heads.


flanndad#17
Member
posted April 03, 2003 08:55 PM
Hey on those 441 heads, if you have a local metal scrap yard go there.
I picked up two sets for $5.oo each this fall.
They usually only charge metal price.
MY local yard is going to sponsor me know, So i go and look thru any motors that come in grab anything I need for free.


budman14
Member
posted April 03, 2003 09:15 PM
i have built a few 355s and i always clearenced my main and rod bearings at 3 thousands ring gap no more than 14 thousands which im just an o hillbilly some profesional engine builder may disagree


rico 08
Member
posted April 04, 2003 11:32 AM
Wow .003 is really loose for the rods,i'd go more towards .002 rods and .0025-.003 mains.Ring gap sounds good for second ring and maybe could be a little wider say .018 on top ring but really depends on you're combo.IMHO


dirtbuster
Member
posted April 04, 2003 11:50 AM
I agree on the brgs.. try to keep them around .0025 You can get by with .003 and a high volume pump but they wont hold up as long. Keeping the clearances around .002-.0025 gives them the greatest load carrying ability yet flows enough oil to keep them cool.


Ring gap can depend on piston type so go with manufacturers reccommendation there.


Back to the Archives