Visit The Dirt Forum for More Information

Author Topic:   phasing H.E.I ?
rfb320
Member
posted March 31, 2003 05:13 PM
i want to weld the dist. but was told it should be phased. can you phase it before you put it in or do you have to run it first to know where it is firing? also how do you do it and where do you weld the dist.?
thanks for the help.


rico 08
Member
posted March 31, 2003 09:11 PM
We used to always use a cap with a hole cut in it with a dist machine and you can see thru the hole if it's firing when the rotor is centered on the lugs in the cap,this can be adjusted with the vacuum advance or block-off if you have one.


Back to the Archives