Visit The Dirt Forum for More Information

Author Topic:   Hot Header Help
ryan
Member
posted March 27, 2003 09:38 PM
Started up the motor to break in the cam. Within 2 minutes #5 header was starting to glow orange. The motor was also missing on 1 cylinder. Checked the lash before it happened and everything was o.k. I don't know if any on the other side were glowing. Didn't go look in time. I don't care if you guys know what is wrong for sure just give me some ideas to try. Thanks guys


jhon hollomon
Member
posted March 27, 2003 10:05 PM
Is your motor runnin lean? You may try to fatten up the jets. What did the #5 plug look like? #1?


ryan
Member
posted March 27, 2003 10:20 PM
Didn't have time to look at the plugs had to head home. I think its lean but why just one cylinder? 78 jets in a quadrajet. 355 10.5 1 Bowtie heads 530-550 lift cam. Same jets as a buddy had w/same motor setup.


sdhnc29
Member
posted March 27, 2003 10:35 PM
Too tight of valve lash on that cylinder most likely . Or you can look at the ignition timing being too retarded . It could also be too rich , and have the fuel still burning as it comes out the pipes . There are a number of other thing's it could be as well , but i'd start here first .

Steve

------------------
Hendren Racing Engines
Rutherfordton , NC
(828)286-0780

[This message has been edited by sdhnc29 (edited March 27, 2003).]

Gene
Member
posted March 27, 2003 11:16 PM
vacuum leak


Back to the Archives