Visit The Dirt Forum for More Information

Author Topic:   Alcohol Washed Bearings
OKC9
Member
posted March 16, 2003 07:24 AM
Open show 383 roller, Shaeffers 20w-50 synthetic oil, MSD chipped at 7200. After about 15 nights, oil pressure dropped. Engine builder disassembled and found rod and main bearings shot with no other measured wear. Sent bearings to Clevite. Engine builder now says the bearings got alcohol washed because of rich jetting. Jetting was set on exhaust monitored full car dyno. Right now we are not sure what to make of the engine builders assessment. Anyone have thoughts on synthetics losing lubrication qualities in alky engines?


sdhnc29
Member
posted March 16, 2003 04:20 PM
If I am understanding correctly , you ran 15 night's on the same oil ?? I'm not too familiar with Shaeffers 20w-50 synthetic oil , but if it is not compatible with alky , then you could definitely have a build up of alky in the oil .

Another possibility could be , if your oil was changed regularly , and you don't have or use a fuel shut off valve , is that you had fuel leaking by the needle and seat in the carb , down into the cylinder's and by the ring's into the pan at one time or another after your car was parked . This would contaminate the oil regardless of how rich you may or may not be . Which would also account for the sudden oil pressure drop . This sound's a little far fetched , but I've seen it happen .

Steve

------------------
Hendren Racing Engines
Rutherfordton , NC
(828)286-0780


OKC9
Member
posted March 18, 2003 05:19 PM
We did change the oil every race or two. We use a KSE pump, but do not have a fuel cut-off. The oil does get that milky look, but it goes away when the oil heats up. We have used Torco and get the same milky look, also Kendall. You may be right about the leak by. Thanks


Slam_Shifter
Member
posted March 19, 2003 10:07 PM
Yankie, I can't find the dyno sheet right now, but the engine builder did change the KSE pill to increase the pressure. I think it tops out at around 9 p.s.i. at 5500 to 7000 rpm. I remember that we had the floats too high for a while. Do you think this may have caused it?


Back to the Archives