Visit The Dirt Forum for More Information

Author Topic:   Bearing Clearance ?
duke
Member
posted February 11, 2003 02:33 PM
I have a sbc with standard mains standard rods. Main clearances check out as follows 1/.003, 2/.003, 3/.004, 4/.003, 5/.004. Can I use +.001 bearings on 3 and 5 to get all clearances to .003. All the crank journals are within .0005. 3 and 5 on the block seem to be .001 bigger then the rest. This is a dirt modified engine. Thanks for any advise.


racer1030
Member
posted February 11, 2003 10:07 PM
Noy a problem. That will work just fine.


Back to the Archives