Visit The Dirt Forum for More Information

Author Topic:   Requesting Advice on Pistons & Intake
RC Racing
Member
posted January 15, 2003 09:11 AM
Looking for guidance for my piston and intake manifold choice. Also, is there a web site that list casting # for intakes?
I'm building a motor for claimer class in SE TX known as "Limited Modified". Engine rule(in part):
360 cubic inch max. Zero deck height. 10:1 four valve relief silverlite cast pistons only. Open chamber cylinder heads 76' or later. 450 max lift hydraulic cam. 1.5 long slot steel rocker arms. No roller tips. No bronze bushings in lifter bore or custom lifters (stock type hydraulic lifters only). ***** in studs and guide plates allowed. 120lb stock dia springs max, stainless valves 1.94 intake & 1.50 exhaust. No angle mill. Steel timing chain. Stock crank and rods. No 6" rods in GM motors. A.R.P Rod, crank and head bolts and studs are allowed. Claimer oil pan & maximum fluid damper allowed. Cast iron water pumps only. Cast iron intakes 76" or later only.
Appreciate the assistance

------------------


Back to the Archives