Visit The Dirt Forum for More Information

Author Topic:   need suggestions on 400 rotating assembly
mdsteacher
Member
posted December 09, 2002 03:26 PM
if it were me personaly i'd run a scat internally balanced crank, 4340 scat i beams, and wiseco pro tru pistons. that should be around 1100-1200$. after that i'd get it all balanced up!

luke

CNC DOC
Member
posted December 10, 2002 08:36 PM
A good bullet proof assembly , that wont break the bank , would be a Callies Dragon Slayer crank , Crower Sportsman rod's , and SRP piston's .

CNC DOC hit the nail on the head about the stock 400 block . Aftermarket main caps are a must have . Keep a good eye on your second main web , eventually it will crack .

Also , do your self a favor and spend a few extra dollar's on the 2925 Super Victor . It is a much better intake that the V/JR ! If you still want the V/JR , be sure to use at least a 1" open spacer on it , but preferably a 2" open spacer . The V/JR has poor fuel distribution to #5 and #7 without a spacer .

Steve

------------------
Hendren Racing Engines
Rutherfordton , NC
(828)286-0780


chief4car
Member
posted December 20, 2002 03:20 PM
Steve,

Hadnt seen you on here in awhile.

I have quick ???

I recently got a mail order catalog that had a Callied DragonSlayer with 400 mains and 3.75 stroke. Previously these were not available.

Are they now available and easy to get??

Thanks
Jim


sdhnc29
Member
posted December 20, 2002 10:00 PM
Hey Jim ,

Yes , they are now available . As far as easy to get , I'd have to call Callies and ask . They are moving a lot of these crank's , so they might be a little behind . But usually they have plenty in stock .

Steve

P.S. Yes it's been a while ! I've been very busy with our business , got married , and have not had much spare time .

------------------
Hendren Racing Engines
Rutherfordton , NC
(828)286-0780


Back to the Archives