Visit The Dirt Forum for More Information

Author Topic:   Rear End Alignment
Rook 78
Member
posted April 03, 2004 08:41 AM
If you measure wb from wheel to wheel it will vary due to caster settings in the fornt spindles. Measure rearend off the lower control arm balljoint grease zerks then double check off some common points on the chassis to compare to.


Rook 78
Member
posted April 03, 2004 09:32 AM
Thanks, my father is old school, and was having a difficult time telling him caster will affect WB measurments and will not give you true lead. I am trying to make rearend square. Thanks for the tip.


NJantz
Member
posted April 05, 2004 07:18 AM
Glad to see you made it here. There is a wealth of information here and some smart folks.

If that mounts are located the same on both sides of the chassis, then you might just measure the lengths of your linkages.

Back to the Archives