Visit The Dirt Forum for More Information

Author Topic:   dirt works wheelbase
WPP
Member
posted March 16, 2004 09:49 PM
I went off the rear tabs on the dw to square the rearend and then i measured the wheelbase and the right side was right but the left side was 5/8 shorter i thought the car should be the same . The car frame is straight


tilley88
Member
posted March 17, 2004 11:30 PM
Where did you measure from? I found that using the lower ball joint zerk fittings gave me the most accurate reading on a DW.


Majic Maker
Member
posted March 18, 2004 07:20 AM
The 3 hole punches that dirtworks says to use on the upper frame rail and drop a plumb down to the rearend is not very accurate! Tilley's method will be your best bet!


Back to the Archives