Visit The Dirt Forum for More Information

Author Topic:   Pinto spindles on a dirtworks
xhubby
Member
posted March 09, 2004 05:57 PM
What all will I need to put pinto spindles on our 01 dirtworks. Bought it without any spindles, & was hoping to avoid a 25lb. penalty,(track rule if you run pinto spindles), & save some money, (running in a limited mod class)by running 68-72 chevelle spindles. (We ran them on our DW6 with no problems w/tube type top a-arms). Put them on our DW8 w/adjustable top a-arms, & we have no angle in the top a-arms. I have no idea what all I need to put the pinto setup on to make it right. What angle do the top a-arms need to be? How much is this all going to cost? Thanks.

[This message has been edited by xhubby (edited March 09, 2004).]

NJantz
Member
posted March 10, 2004 06:46 AM
NJantz, Thanks, you wouldn't by chance have a part # for the longer balljoints would you? I may already have them on the car. Not sure of the part # we have on the car right off the top of my head. Thanks again.


xhubby
Member
posted March 12, 2004 10:33 AM
Would anybody else know the part # for the longer ball joints? Do they make longer ball joints for both the top & bottom, or just the tops? Thanks.


NJantz
Member
posted March 12, 2004 10:34 AM
Thanks, I'll try that.


Back to the Archives