Visit The Dirt Forum for More Information

Author Topic:   427 S.B.
crob
Member
posted January 25, 2004 07:15 PM
I would like to bild a 427 s.b.chevy with a dart block and a good crank. With 18 degree heads ??????????

------------------

[This message has been edited by crob (edited January 25, 2004).]

sixwillwin
Member
posted January 25, 2004 09:08 PM
Great!! Build me one too!!


nwdirtmod2
Member
posted January 25, 2004 09:18 PM
I would like one also. Sounds like a good idea. Go for it.

------------------
Keep it sideways!


crob
Member
posted January 25, 2004 09:37 PM
Do's ane one now what to use to build it. Like what crank ,rods,pistons,block,to use.?????????????????????


nwdirtmod2
Member
posted January 25, 2004 11:49 PM
I would post your message in the engine tech section. You may get more advice there.


Greggie
Member
posted January 26, 2004 07:26 AM
I'm pretty sure it is a 400 bore that is standard with a 4" stroke. Usually 6" rods. My 434 is a .030 over with a 4" crank and 6" rods.


chomme
Member
posted January 27, 2004 09:43 AM
I will keep you in mined


dirtywrench13
Member
posted January 29, 2004 06:54 PM
Call Mark Niebes motorsports in Garrison Ia,he builds a lot of h.p. in a dart block! I saw a dyno sheet on one that was over 800 h.p.,then he used a good carb at the track!(my davinci)May have had 18*heads also.


Back to the Archives