Visit The Dirt Forum for More Information

Author Topic:   J bar vs. Panhard height mounting
ScottGreer
Member
posted December 14, 2003 09:43 PM
What kind of rear roll center height difference should one loook for when switching from a standard 22 in rear mounted panhard bar to a 20.5 in j-bar? Should the bar be mounted in a lower fashion to accomidate the postive change in angle due to pinion angle change? What is a good starting spot for angle on a 4bar/z-link car?
Thanks


zeroracing
Member
posted December 15, 2003 07:31 PM
put the car at ride height and put j-bar in second hole up from the bottom then measure from the center of the bolt to the ground. then go over to the frame side and mount that side 4 inches higher from the center of that bolt and that should get you about right, good luck


Greggie
Member
posted December 16, 2003 05:09 AM
GAWD Zero, you just hurt my brain with that equation stuff... LOL

Greggie

Back to the Archives