Visit The Dirt Forum for More Information

Author Topic:   Pan-hard bar
WPP
Member
posted October 12, 2003 08:03 AM
I am running a straight bar on the left side about 16inches should the bar be straight with the pinion from the mounting points i have seen some angled back to the pinion . Is there a differce


zeroracing
Member
posted October 12, 2003 01:10 PM
Maybe i did not explain this very well i was asking about the pan-hard bar at side to side should the bar be straight on the chassis to the pinion or angled back toward the pinion thats what i meant i have notice some are angled back towards the pinion i have mine shimmed on the chassis and the pinion were the panhard bar is straight in line


2nd2none
Member
posted October 12, 2003 05:51 PM
the new dirtworks have the bar raked in to the pinion about 1 inch from the frame. I believe this is done so when the rearend is rapped up the bar is more parallel and no binds.