Visit The Dirt Forum for More Information

Author Topic:   Alky To Gas
bachshute
Member
posted September 11, 2003 08:35 PM
carb, fuel pump, filter


ctfarm
Member
posted September 12, 2003 07:52 AM
All we do is,flush the lines with gas,change the carb and set the fuel pressure.



dirtbuster
Member
posted September 12, 2003 07:59 AM
it woudl depend on the rest of your fuel system. If you have a belt drive pump and regulator system then all you would have to do is drain the old fuel refill, and change carbs. With mechanical block mounted pumps you might have to change pumps in order to get an adequate amount fo fuel to the engine or vice versa.


bachshute
Member
posted September 12, 2003 01:24 PM
Setting the regulator would depend on what you have it set at now. If you have it set around 7psi ro so it will prob work fine. I dont think you need anymore than that with gas.

As for the shroud and restrictor, it would all depend on your cooling system. If you have a small 1" radiator you will have to put in a bigger radiator to cool the gas engine down. If you have the small rad and no thermostat and still run 190 i dont think you will ever keep gas cool enough. Go to a big radiator, and good fan and see if it works. then add a shroud later if you need to. Make sure you have it jetted right. This will make a big difference.

bachshute
Member
posted September 15, 2003 07:27 PM
thanks for the info everybody ,