Visit The Dirt Forum for More Information

Author Topic:   Rearend Question, Dirtworks
driver27
Member
posted September 09, 2003 10:16 AM
One of the easiest and quickest way to get it close, is with the car at ride height, stand at the back of the car with the rear hacth open, and line up the driveshaft with the bar on the frame where the pull bar mounts on the chassis. That is the fastest way to get it close, if we need to re-center the rearend at the track that is what we do. The other way is with plumbobs, and it is more accurate, but more time consuming. The Dirtworks page has the info on how to do it on their tech support page

[This message has been edited by JMillerJr76 (edited September 09, 2003).]

2nd2none
Member
posted September 09, 2003 11:13 PM
Most of dirtworks newer cars are using a 58" rearend. A 60" rearend centered will work just as well.