posted July 22, 2003 11:14 AM
can someone help me out, i'm putting diferent spindles on my mod, what gm product uses an 11 in rotor with a 5x5 bolt pattern stock.
posted July 22, 2003 01:48 PM
You are going to have to redrill for 5" on an 11" (factory 11"s are all 4 3/4) They do have differant bearings to watch out for.
posted July 22, 2003 02:54 PM
Why not just put the bigger 5x5 rotor in a lathe and turn off some OD?
Ryan Lingner Member
posted July 22, 2003 03:09 PM
That would be against most tracks rules and for sure against IMCA rules if he runs at those tracks.
posted July 22, 2003 08:26 PM
Used to do this at Harris Racing all the time, either redrill the 11" rotors to 5x5 or turn the 5x5 12" rotors down 1" and put them on the 11" spindles providing the bearings are the same.
posted July 23, 2003 05:58 PM
I guess I should have been specific I have a 97 harris thats what I'd like to put them on charlie needham