Visit The Dirt Forum for More Information

Author Topic:   Gaerte Sliders
A2KY2K88
Member
posted June 17, 2003 02:34 AM
After taking the snap ring out of the slider, how do you get the "guts" out to replace??


speedy79
Member
posted June 17, 2003 06:12 AM
Take the top heim out and you can get a allen drive down into the body. Loosen this up and the shaft will fall out. Now take a long punch or a skinny ***** driver and you should be able to knock the assembly out. When you go to rebuild it is important to put the shaft and the assembly back together before you slide it in the body. If not its almost impossible to start the pan head back into the shaft. First one takes a little time, after that they take about 15 minutes to rebuild. Also watch that you dont bottom the greese zerk out into the assembly, when you go to put greese in it it will bind up or blow the seal past the snap ring. Trust me, I did this. Hope this helps.


Back to the Archives