Visit The Dirt Forum for More Information

Author Topic:   Caster/Camber
PEDDLER
Member
posted March 13, 2004 07:54 AM
Could some one give me the R & L Caster/Camber settings that are recommended by the chassis builders for a Monte/Cutlass/Regal type of metric car.

Thanks

PEDDLER
Member
posted March 14, 2004 10:11 AM
Well I guess that everyone guesses at the settings...Out of 41 views I would think someone has an idea.


DEEDDUDE
Member
posted March 14, 2004 10:28 AM
peddler, I'm no chassis builder even though I've built a couple, this is what works for me LF: +1* camber, +2* caster, RF: -3* camber, and +4* caster. Tire temp. will help dial it in. Watch the RF this will shorten this side more than left and it may put you below the min. wheelbase. good luck


Limited Mod 57
Member
posted March 14, 2004 03:07 PM
Peddler, wouldn't hurt to listen to Deed. I've seen him run his car and it's not H/P keeping him up front.

------------------


PEDDLER
Member
posted March 14, 2004 03:19 PM
Thanks Dude


PEDDLER
Member
posted March 15, 2004 08:08 PM
Any more comments...bump^


bobaluuu
Member
posted March 15, 2004 08:45 PM
warning you probably can't get even to 0 camber left side with out an offset shaft kit or moving the mount. If you can weld
you can move it in a couple of hours easy.
smooth cut/clean grind/good beads and paint
make it hard to spot

------------------
Light it up, Baby!


Back to the Archives