Visit The Dirt Forum for More Information

Author Topic:   CAST & CAMBER
dirt poor racing
Member
posted March 09, 2004 06:31 PM
PUTTING NEW SPRINGS ON THE FRONT AND SWAPPING OUT STROUTS IS THERE ANY WAY TO CHECK CAST AND CAMBER WITH OUT TAKING IT TOO THE ALIGNMENT SHOP WON'T GET TO FINISH SWAP TILL NIGHT BEFOR RACE, NEED INFO.....OLD SPRINGS WERE 14 FREE HIEGHT 500# NEW SPRING 9.5 1200#


joetaylor
Member
posted March 09, 2004 06:58 PM
If you can get a angle finder guage with a magnet you can set the camber with it I stick it to the roter nowyou will have to suppot the lower controll arm out by the ball joint. if you had the guage befor you changed the spring you could have taken the measurement befor then put it back

as forcaster it shouldn't have changed

------------------
U LIFT U LOOSE


dirt poor racing
Member
posted March 09, 2004 07:07 PM
thanks...


Back to the Archives