Visit The Dirt Forum for More Information

Author Topic:   A-Arm Bushing Install Question.
Flanndad
Member
posted March 01, 2004 05:26 AM
How do you take out the upper cross shaft on the a-arm.

I let the old rubber bushings burn for a while, do you just drive it out with a hammer?
Or is there a lock ring or something in there i'm missing?

The lower's look like you just heat up the steel sleeve and drive them out with a hammer.

Any idea's, please help.

c21
Member
posted March 01, 2004 09:16 AM
the best way to do it is with two guys and 2 air hammers, one on each side of the outer lip. it might take a few mintues to knock it loose but then they just fly out

[This message has been edited by LUBEGUY07 (edited March 01, 2004).]

toddr46
Member
posted March 01, 2004 07:08 PM
Air hammer, or be real careful with a torch.


Back to the Archives