Visit The Dirt Forum for More Information

Author Topic:   clutch problem
Racer98
Member
posted February 22, 2004 11:22 AM
I have my clutch together, and need to know how close the throw out bearing should be to the pressure plate. please help


pit_boss
Member
posted February 22, 2004 08:00 PM
Your T.H. bearing should have some clearance between it and the clutch fingers, just enough so the bearing will make contact only when the clutch pedal is depressed..... Jim


way2fast72
Member
posted February 22, 2004 08:09 PM
is it stock clutch linkage or hydraulic throw out bearing? some hyd, manufactures recommend that the bearing just touch the fingers, never made much sense to me,but always did as they recommended and no problems.


c21
Member
posted February 23, 2004 08:53 AM
typically you should leave from .100" to .187" between clutch fingers and bearing .... this allows for wear on discs (which in turn reduces the gap) and ..... some clutches rely on centifical force to increase clamping at higher RPM's (which moves fingers closer to bearing when this is occuring).

c21

[This message has been edited by c21 (edited February 23, 2004).]

Back to the Archives