Visit The Dirt Forum for More Information

Author Topic:   ?s on redrilling front rotor bolt pattern
unlucky13
Member
posted February 19, 2004 08:34 PM
There is a very good post about 2 or 3 months ago. Go back and it will walk you threw and answer all your questions. Go back or do a search for drilling rotors.


eaton89
Member
posted February 19, 2004 09:12 PM
It was posted in november by 66jj.


RangeRover
Member
posted February 20, 2004 06:19 AM
Speedway Motors sells a 5 on 5 hub adapter that is 1# thick that adapts 5x4.5 and 5x4.75 to 5x5 cost $69.95. Eddie


dan63
Member
posted February 21, 2004 09:44 AM
I used granada rotors on metric spindles. I had to turn down the outside diameter of the rotor for clearence. Use the gm bearings and on the 79-82 metric spindles I had to use a couple extra washers between the outer bearing and nut.


Back to the Archives