Visit The Dirt Forum for More Information

Author Topic:   Heads??????????????
BIGDADDYBOZ
Member
posted January 10, 2004 11:15 PM
I bought a 383 with a Team G intake and Dart Iron Eagle heads and tried to put my Performer Intake on it and it is way off of lining up. Anyone ever had this prob and what do I do? Thanks


Elmo
Member
posted January 11, 2004 12:44 AM
If the heads have been milled then you have to mill the intake to match. Either angle milled heads or flat milled. Maybe this is your problem.


wildmankcarroll
Member
posted January 13, 2004 12:23 PM
there could be more to than just the heads have been milled, the block may have been decked, ultra thin head gasket, is your intake virgin? If the heads have been milled i would take them to the machine shop and have the intake side of the heads milled so you can change intakes without the hassle of having every intake you put on it cut to fit. getting the intake side of the heads milled will let you use standard intakes.

------------------
Wildmankcarroll


Back to the Archives