Visit The Dirt Forum for More Information

Author Topic:   Driveshaft into Tranny Depth
RangeRover
Member
posted January 08, 2004 05:42 AM
Probably best to hear from scott first but: I've always put the yoke in all the way then pulled it out 1" and measured there.


avila
Member
posted January 08, 2004 01:51 PM
I run a 350 with a 3 speed gm 8.5" 10bolt.
When slip yoke is engaged into tranny, I only
see about 3/4" of the shinny slip yoke.


jammin james
Member
posted January 08, 2004 04:32 PM
we push it all the way in and pull out 1.25"


prostock15
Member
posted January 08, 2004 05:29 PM
Dont know about the depth of the slip yoke but the vibration could in part be not having the tires balanced. Its just a thought but I'm sure that could cause some of the steering wheel vibration.


powerglides
Member
posted January 09, 2004 09:23 AM
With a stock type slip yoke you should have 1"-1 1/4" between rear seal and shoulder on yoke with car setting on ground.


Back to the Archives