Visit The Dirt Forum for More Information

Author Topic:   upper a arm
pbk
Member
posted December 09, 2003 06:35 PM
I want to change the stock a arms to aftermarket ones how do i figure out what length to buy?Any info would be helpful,Thanks.


racer17j
Member
posted December 09, 2003 08:50 PM
if it's for a metric or a camaro speedway sells stock replacement tubular uppers now like 45 each without ball joints


Dixon
Member
posted December 10, 2003 02:04 PM
Do you shim your stock A-arms for camber changes? Sometimes it's hard to get enough on the left front, so going with one slightly longer than stock on that side can allow more adjustability.

If you measure the stock piece perpendicular from the bushings/mounts to the center of the ball-joint, that should give you your length.

bobaluuu
Member
posted December 10, 2003 10:34 PM
I have some aftermarket bolt in metric tubular uppers for both left and right sides in diff lengths for off sets/they use factory or afco ball joints 4 total will sell for 150 total and a couple balljoints and a couple howe uppers with heim joints to
throw in with the deal. send me a p.m.