Visit The Dirt Forum for More Information

Author Topic:   hyd. clutch setup
wermm
Member
posted November 23, 2003 07:39 PM
i am just wondering if you guys like the hyd. throwout bearing or a slave cylinder better. I have a pedal and a slave but most of the people around here run the t/o bearing. I finally decided to go from my glide to a 3 speed this year.


jhon hollomon
Member
posted November 23, 2003 08:52 PM
I'd say the throwout bearing is the prefered method but the slave cylinder will do the job as well.

------------------
Just a little crazy!!!!!!


eborcim
Member
posted November 24, 2003 03:52 PM
hyd. throughout brg. for stock type clutch is a pain to adjust, but they work ok.


wizzard
Member
posted November 24, 2003 06:32 PM
we ran a hyd t/o bearing and neil's rite they are a pain to adj. but once ya got it they work good no extra brakets to mess with and even with the bell stuffed into the firewall it still worked to get the car stoped after i got hit real hard.you'll get real good at pulling and installin your trans while you adj. it tho.