Visit The Dirt Forum for More Information

Author Topic:   side exit headers
DMS CEO
Member
posted November 11, 2003 02:00 PM
Does anybody make them for a monte that has stock clutch linkage and engine set back to number 1.


redneck racing
Member
posted November 14, 2003 07:50 PM
You might be a ble to get a set from Hooker but they are costly. Go down to your local parts store and find someone knowledgable on the subject. The headers I used were off a 77 Camaro front steer and the racer was a 73 Nova rear steer and I ran the 3 speed tranny. You might shoot ffor something along that line. Eddie


66jj
Member
posted November 14, 2003 08:25 PM
Dms,

I thought you wanted side exit headers, as in over the frame and out behind the front tires.

you want headers from schoenfeld parts store headers are too low, and wont clear angle plug heads etc.

they will not clear stock clutch linkage.
will clear rear mid mts, and angle plug heads.
159.95 #186 1.75 diameter

schoenfeldheaders.com




istock59
Member
posted November 14, 2003 09:15 PM
While we're on the topic of headers, I've had both Schoenfelds and Dynatechs in my metric chassis. The Schoenfelds seem to fit better (more clearance), but the Dynatechs are better made (better welds,etc). How's that for indecision? LOL..

Right now I've got a set of 1.5" step headers from Schoenfeld that I really like. Dynatech didn't make a 1.5" tube...

[This message has been edited by istock59 (edited November 14, 2003).]

bobaluuu
Member
posted November 17, 2003 09:38 PM
[QUOTE]dyna-techs and turn em upside down
my neighbor did this, god are they noisy but it worked. had to can cap em after races to
keep water and debris out


Back to the Archives