Visit The Dirt Forum for More Information

Author Topic:   IMCA hobby stock motor mounts
Eagle71
Member
posted October 24, 2003 08:22 PM
I have heard you run a Chevy v-8 upper mount and a lower v-6 that would make a solid mount but, I found when I do this the motor sits way to high. Is there a special v-6 mount that I'm not finding? Also it has to be an oem mount the rules state. Thanks
Ed


Eagle71
Member
posted October 24, 2003 08:39 PM
Also I don't think its legal to cut and weld to make the mounts the way i want.


racer17j
Member
posted October 24, 2003 10:19 PM
i always just run the stock v8 mounts on bolth keeps things alot simpler


gould
Member
posted October 25, 2003 05:13 AM
also use the bolt holes that are 1 1/4" farther back. acording to a good source of mine, it will gain you 2 to 3% rear percentage.

------------------
Drive it in deep, and come out hard!!


MEANGENE83
Member
posted October 25, 2003 06:27 PM
the mount you need is off a 231 buick. it will sit about an inch higher than stock.


Back to the Archives