Visit The Dirt Forum for More Information

Author Topic:   tranny mount
gould
Member
posted October 14, 2003 07:49 PM
when fabricating this do i need the carb plane level or should i base it off the drive shaft or just split the difference?


gonfast
Member
posted October 14, 2003 09:19 PM
whayt kind of mount are you tring to make? the crossmeber or the mount on the tranny it self

[This message has been edited by racer17j (edited October 14, 2003).]

gould
Member
posted October 15, 2003 06:08 AM
crossmember


gould
Member
posted February 25, 2004 05:28 PM
ok another question, does the rear of the tranny need to be centered or off to one side a little. just wondering if i need a little pressure on the u joint. if so how much?

------------------
Drive it in deep, and come out hard!!


gould
Member
posted February 25, 2004 07:49 PM
^^^

------------------
www.geocities.com/gouldracing11


Ego Racing
Member
posted February 26, 2004 06:46 PM
Trans should be in straight line with the chassis.


Back to the Archives