Visit The Dirt Forum for More Information

Author Topic:   Small block ford exhaust.
hobby62
Member
posted June 29, 2003 10:55 PM
There is some stock early cast manifolds that will flow more and better than those choked down stock tubular ones.


nate 11
Member
posted June 30, 2003 04:09 AM
wizzard? where are you? this man needs blue oval help...if wizzard don't reply to this post pm him. he's the wizzard on fords.


outlawstock17
Member
posted June 30, 2003 08:13 AM
the 69-70 351w exhaust manifolds flow about the same as the late model 1 1/2" "squished tube" shorty headers, maybe a little better. the 351w manifolds will probably cost you a lot more though. they are getting hard to find.

[This message has been edited by outlawstock17 (edited June 30, 2003).]

ford5
Member
posted June 30, 2003 06:38 PM
outlaw is correct.....the shorty pinched tube headers aint worth a hoot.....tryed them once around 96 i think.


hobby62
Member
posted June 30, 2003 06:44 PM
I heard that they make a replica to the early 289 hi/po manifold. Are they as good as the stock ones? Has anyone used or seen them ?


wizzard
Member
posted July 01, 2003 08:50 PM
ive used the stock shorty but to make them work weld around the outside of the tubes by on the top and grind the weld off the inside then use a pipe expander and open the colector up


Back to the Archives