Visit The Dirt Forum for More Information

Author Topic:   tranny cooler
chad01j
Member
posted June 20, 2003 07:11 PM
i poked a hole in one of my tranny cooler tubes about the size of a pencil tip. if i cleaned it good would "j-b weld" hold i cant braise it before sat and dont have tie to get another.

Thank You

racer17j
Member
posted June 20, 2003 07:30 PM
jb isn't a very good idea it can get inside the cooler and cause some real trouble . myself i don't run a cooler only time i ran into trouble was running in 1st gear on a 1/2 track turning 6400 was a little to much for it i guess and it finally blew on me after 2 years or running in 2nd.i'd just put plugs in the lines or just make a loop and connect the two lines one nite shouldn't hurt you none


MOD75D
Member
posted June 21, 2003 08:59 AM
I agree. I ran a tci power glide in my mod and never ran a cooler and never had a problem.


Back to the Archives