Visit The Dirt Forum for More Information

Author Topic:   A arm help
Fomocosho
Member
posted June 03, 2003 08:24 PM
Has anyone heard of aligning a arm holes? This is an option on Terminator Chassis and I was wondering If I should do it and how it is done. I am building a metric car for IMCA hobby stock. Thanks


CUSTOMPERFORMANCE
Member
posted June 03, 2003 09:49 PM
Drill out the lower a arm holes in the crossmember to 1 or 2 sizes bigger than 1/2 and then stick a 1/2 solid rod on each side and align the rear lower arm holes with the front. When done use some washers with a 1/2 id hole and weld on each side of the lower mounts. This trues up the lower a arm mounts and takes some bind out of the frontend. I do it on all my modifieds i build.


allan
Member
posted June 04, 2003 05:56 PM
hey ,is there any web sites or books that relate to what cust.perf.is talking about?


Back to the Archives