Visit The Dirt Forum for More Information

Author Topic:   push
ss38k
Member
posted May 19, 2003 09:34 PM
if i stiffen the right front spring. from 1200 to a 1300 will it help the push. it push's from the middle out. Lf has a 1000 in now .i also have a 1100 and a 1300 to put in if it is going to make it better. back has a 200 and a 250.going to scale car tomorrow it was about 52 left .rear was around 50.5 but we moved motor back 4" over winter i have been told rear % will be higher not sure how much yet .thanks for any help not sure what cross was wright now .what do i want.thanks


rico 08
Member
posted May 19, 2003 09:41 PM
In general try to look at handling this way,if you have a problem going in look at the front suspension more,coming off the rear more,this is just generally and the suspension all works together,i'd maybe try more stagger on the rear and maybe a wheel spacer or more offset on the left rear to start.


ss38k
Member
posted May 19, 2003 11:27 PM
thanks rico 08 i was thinking stager or wheel offset's.and i have been trying to find some 1" spacer's. seam's like everyone is out of them .thanks for the advise tryed speedway today.by moning the left wheel out will that help losen me up some rico.i just was not sure if i was thinking in the wright ways.

[This message has been edited by ss38k (edited May 19, 2003).]

[This message has been edited by ss38k (edited May 19, 2003).]

AUS RACING
Member
posted May 23, 2003 06:43 AM
if you are getting a push from the middle of the turn & out your left rear is probably providing more drive than the right


CLBaker25
Member
posted May 23, 2003 07:07 AM
I would lower your right front spring to a 1100. That will loosen the car in the middle.

Baker

Back to the Archives