Visit The Dirt Forum for More Information

Author Topic:   spring spacers?
Racer98
Member
posted May 18, 2003 04:04 PM
I was wondering about putting adjustable spring spacers in my car, but I run 12 inch springs that rate 1100 lbs, and they seem hard enough to put them in the way it is, just wondering if other have put this in with the 12 inch sring?


loojack
Member
posted May 18, 2003 06:08 PM
Usually spring spacers are used with racing height springs around 9 1/2" tall. It would be very hard to use them with 12" tall springs. Hope this helps ..loojack

------------------
"loojackracing, a not for profit organization"


Kent
Member
posted May 19, 2003 08:39 PM
I had a nose high problem with my car because of my low spring rates in the rear. I went to the 91/2" hypercoil springs in the front but then I had a problem with bottoming out my front suspension. I welded in the hidden adjustable spring shims and now I can set the ride height and stagger! It is a little bit of work but I think well worth the effort! Good Luck!


Back to the Archives