Visit The Dirt Forum for More Information

Author Topic:   wiring ?
rfb320
Member
posted May 03, 2003 11:24 PM
I am in the middle of wiring my car and was wondering what size wire to run from the battery to the ignition switch and then out to the ignition? I had read that your not supposed to use to small of wire because of the draw of the ignition at high rpm's, but the article didnt say what size to run. thanks for the info.


hsracer58
Member
posted May 03, 2003 11:39 PM
Just wired ours this weekend. The MSD ignition has 12 gage wire for the battery and recomends using 10 gage if you're extending the length of the wires. That's what I did. And used 18 gage for the rest of the wire to the dist. ground and ignition switch.

------------------
Scott Vosevich


powerglides
Member
posted May 15, 2003 06:31 AM
I would not run smaller than #10 wire. That is what is on stock HEI setups.

[This message has been edited by powerglides (edited May 15, 2003).]