Visit The Dirt Forum for More Information

Author Topic:   Seat Belt Install?
4d_POWER
Member
posted March 12, 2003 07:58 PM
My seat was mounted directly to a bracket on the main cage cross bar of the roll cage to get it set back as far as possible.

The cross bar is right up against the seat and right below the seat belt hole.

#1..What's the best way to mount the seat belt tabs keeping my safety in mind as the main goal?

#2..Also I haven't ordered my belts yet, Do you have preferences as to Cam-lock vs. Latch-n-Link?

#3..Also do the belts come with Good Mounting Instructions??

gould
Member
posted March 12, 2003 08:05 PM
i had the same problem. i had a piece of 1 1/4" tubing bent 180 degrees on a tight radius. i then cut a piece for a kicker for extra support. mount your seatbelt tab inside the radius. also be sure you get the correct angle for your belts. this worked real well.

------------------
Dirts for racin', asphalts for gettin' there!!


4d_POWER
Member
posted March 12, 2003 09:06 PM
That sounds pretty good, relatively simple as well!
Thanks!


sideways
Member
posted March 13, 2003 07:51 PM
i have a piece of 1/4 in steel welded to my cage and bolt the shoulder straps to it the main thing to keep in mind is make sure they are below the level of your soulders and the lap belts should be at a 45* angle to your hips here is a pic of mine


Back to the Archives